E-Lab Modules


EDE16020 20 Amp H-Bridge DC Motor Controller Module
Ultra-high efficiency and tremendous performance!

Terminal Block Board available this September

Download EDE16020 datasheet




EDE12400 Bi-Polar Chopper Drive Stepper Motor Control Module
A complete chopper drive system in a 1.75" PowerCube™ package!







Download EDE12400 datasheet


 

Assembled Keypad Module (front & back shown)

  • Automatic key repeat after delay
  • Contact debouncing
  • Key beep provides tactile feedback to operator
  • Electrically quiet (reduced EMI) non-continual keypad scanning
  • Data valid signal prior to serial transmission
  • 2400/9600 serial Baud rates selectable
  • Interfaces to any micro or direct to serial port
  • Both 5V TTL level and true RS232 level transmission
  • This unit reduces I/O pin requirement from 8 to 1
  • Carriage Return & Backspace supported



Assembled Serial LCD Modules
  • 2x16 or 4x20 (shown above) sizes available
  • 3 wire interface (+5V,GND,Serial In)
  • Software controlled backlight
  • Destructive backspace and cursor positioning
  • Displays 8 stored custom characters
  • Accepts 0-5V (TTL) or standard RS-232 voltages
  • Baud rate 2400 or 9600, standard or inverted.
  • Contrast control via onboard pot. 



    • Stepper Motor Controller Module Kit (unassembled)
  • 1¾ x ¾ inch pre-drilled circuit board with 15 pin right-angle SIP header
  • EDE1200 Unipolar (5 or 6 wire) Stepper Motor Controller IC
  • ULN2003A Power Transistor IC
  • 4 MHz Resonator
  • Zener Diode & Bypass Capacitor
  • EDE1200 and ULN2003A Printed Datasheets
    • Download the Stepper Motor Controller Module Kit Pinout and Assembly Instructions in Adobe Acrobat (.pdf) format.


    As this module uses the EDE1200 Stepper Motor Controller IC, you may wish to download the EDE1200 Datasheet as well. It is available in the Integrated Circuits section, accessable from the main page.
     

    If you do not have the Acrobat Reader program and would like to download it, click here .

    Ordering Instructions

    Orders may be sent via e-mail, postal service, phone, or FAX.

    Click here for our Online Credit Card Order Form.
     
     

    E-Mail: sales@elabinc.com

    E-LAB Digital Engineering, Inc.
    1600 N. 291 Hwy. Ste. 330
    P.O. Box 520436
    Independence, MO 64052-0436
    USA

    Phone: (816) 257-9954

    FAX: (816) 257-9945


     
    Visa, MasterCard, Prepaid, and U.S. COD orders are accepted. US orders please add $5 Shipping. COD add $5.
    Foreign orders add $8.00 Air Mail shipping.
    All Prices shown are in US Dollars and are subject to change without notice.